For close monitoring of orchards, vineyards, and other high-value crops, Botanist recommends planning for 1–5 soil sensor probes per hectare, depending on field variability. Another useful starting point is three probes per irrigation zone: two in representative, healthy areas and one in a weaker area.
A single sensor can help you decide when to irrigate. Several well-placed sensors help you understand whether that decision works across your field.
Botanist sensors are affordable and easy to install, making it practical to compare more locations and investigate differences that a single probe could miss.
Sensors per hectare: a practical guide
| Density | When we recommend it |
| 1 probe per hectare | Relatively uniform soil, terrain, and crop growth. |
| 2–3 probes per hectare | Noticeable differences in soil, slope, or crop performance. |
| 4–5 probes per hectare | Highly variable fields, intensive monitoring, or investigating recurring growth problems. |
Choose your density based on the differences you need to capture:
- Soil conditions: sandy patches, heavier soils, shallow ground, or poor drainage.
- Topography: slopes, raised areas, and low spots where water collects.
- Irrigation: separate watering schedules or differences in water delivery.
- Crop performance: areas that consistently grow better or worse.
These are Botanist’s practical recommendations for closer monitoring, rather than universal requirements. Large, uniform fields can need fewer sensors. Oregon State University recommends at least two monitoring locations per management zone and notes that two may be sufficient in relatively uniform fields of up to approximately 16 hectares. The important factor is how much conditions vary.
Start with three sensors per irrigation zone
For an area watered together under the same schedule, start with two sensors in representative, healthy areas and one in a weaker area.
The first two provide a reference for irrigation decisions. The third helps you investigate why part of the crop performs differently.
Choose healthy areas with typical soil and growth—not only the best-looking plants. Representative locations make readings more useful for irrigation scheduling.
If there are two distinct problem areas, add a fourth sensor. For larger or more varied zones, use the per-hectare guidance to expand coverage. Different soil types should have their own monitoring locations.
Find out what is holding an area back
A weaker patch does not automatically need more water. Comparing it with a healthy area can reveal useful patterns:
- It dries out sooner: investigate lower water storage or insufficient water delivery.
- It stays wet longer: investigate drainage, excess irrigation, or reduced water uptake.
- Only the shallow soil gets wetter: check whether irrigation reaches the deeper roots.
- EC is consistently higher or lower: check for differences in salt accumulation or fertilizer distribution. Soil type and moisture also affect EC, so compare these readings together.
For example, if a weak patch stays wet while healthy areas dry out, increasing irrigation across the whole zone may make the problem worse. That comparison gives you a reason to inspect drainage and root conditions before changing the watering schedule.
These measurements help you decide what to investigate, even when watering is not the main problem.
Does a multi-depth probe count as several sensors?
For the recommendations above, one probe counts as one monitoring location.
Botanist probes measure soil moisture and EC at two or three depths, depending on the model. This lets you check whether water reaches the deeper roots and which soil layers dry out first. Each probe still measures one location, so placing several across the field helps you capture differences between areas.